Specifications subject to change without notice
The Sullair breakers have eliminated most high-wear parts. Fewer parts mean less wear, less maintenance, and less downtime.
Unlike conventional breakers, Sullair breakers have no multi-part tappet system. With fewer parts, wear is reduced and risk of air leak is minimized. With no tappet system, which requires three independent impacts, noise is also reduced.
A leakproof air cushion forms at the end of the piston stroke and stops the piston from direct impact when the tool is not breaking. The elimination of side rods, nuts, and springs makes Sullair breakers sleeker and more comfortable to operate.
With only two parts moving during operation, normal oil carry-over from the compressor, combined with moisture in the air, will usually provide sufficient lubrication under normal operating conditions. Manual lubrication before storage is sufficient.
One moving impact part minimizes maintenance.
Standardization of design permits a high degree of interchangeability of parts between Sullair models.
The piston, impacting directly on the steel shank rather than a tappet, reduces noise level of the breaker.
The flex handle option reduces up to 60% of the vibration to the operator without a loss of power.
Reduced kickback is less fatiguing to the operator.
Durable double roll pin permits easy steel changing.
The direct impact piston design, non-corrosive distribution valve and one-piece housing dramatically reduce air consumption. You can operate more tools from a single compressor. For example, a 125 cfm compressor will operate two MPB 90 breakers.
All Sullair breaker parts are warranted for two years against manufacturing defects. Additionally, should a part wear out during normal operation, it is covered by Sullair's exclusive two-year warranty.
